The tile is a popular coating for floors and walls in bathrooms where surfaces need to resist water and moisture. Although a bit more expensive than linoleum flooring or fiberglass for shower walls, tile increases the value of a home and gives a look of quality. Place tiles in your bathroom is a project that you can perform yourself with the right tools and go to the website  to choose ceramic tile .

 

tiling a bathroom

Instructions

 

Application floor tile

 

1

Strengthens the ground before laying the tile. The method which is usually used is smooth a thin layer of mortar on the floor covering with a panel of cement before it sets. Use screws to hold the panel. This provides a robust and secure surface for placing the tile.

 

2

Start at the center of your room when you place the first tile. Make two straight lines with a chalk line to use as a guide. The first to go from the middle of the longest wall, parallel to the wall at the exact center of your room. The other line should be perpendicular to the first between the adjacent walls. Using as a guide wall longest reduce the effect of an uneven soil zone.

 

 

3

Extends above the ground level layer in a thin-starting point, keeping a portion of the chalk line visible for use as a reference. Using the end of the notched trowel to spread the layer with a thickness of about 1/4 inch.

 

4

Place the tile outlet at the corner of your chalk line and handle it by placing it in place on the mortar. If you want, you can put spacers on each side and add more tiles, keeping them level with which you have already placed and with lines.

 

5

Continue until you reach the end of the wall. Measure and cut the outer tiles you place using the tile saw. A wet saw is superior to dry because it reduces the heat generated by the sheet, preventing the tile is filled with dust and chipping. Wait 24 hours to get noticed before emplastecerlos.

 

6

Mix the grout according to package directions. You can use one without plaster or sand blasting, although containing sand is normally used for soil and do not have it from the walls. Use a trowel to spread the plaster between the tiles. Let it dry for 20 to 30 minutes, then clean with a sponge or a wet cloth the excess. When completely dry, rinse the tiles with a damp cloth to remove any scratches. Wait 24 hours and apply a plaster sealer according to package directions to avoid stains.