We adopt the total look or that the band prefers to accent the wallpaper, with 1001 patterns and textures, has an unparalleled ability to enhance decor. But the pose gives you a headache, you say? Learn how to install the wallpaper on a wall in simple steps in order to refine illico style of any room. Grandiose effect provided with minimal effort! Before you begin, take care to protect your floors by covering them with plastic wrap. Also, note that using a pre-pasted wallpaper will make it easier.

Step 1:

Using a degreaser without rinsing, as TSPe, wash the mounting surface. If the wall has cracks or holes, repair them with wood filler.

Step 2:

Using a roller, apply one coat of primer on the wall to seal it and make sure that the wallpaper adheres well. Allow to dry. Helping you to a level, draw reference lines on the wall at a distance equal to the width of your strips, which will help you ask the wallpaper straight. Note that it is recommended to start laying in the center of the wall.

wall-paper

Step 3:

Cut the first strip of wallpaper to length, adding about 5 cm (2 inch) margin of error. Wrap the paper itself, grounds to the inside, then immerse it in warm water for about thirty seconds. Remove the le, drop it on the floor and fold it in some sections, glued side on adhesive side. Let the wallpaper in this position for five minutes to allow the adhesive to activate.

Step 4:

Then attach the first strip on the wall, aligning it with your guide lines. Let the excess wallpaper exceed about 2.5 cm (1 inch) ceiling and floor. Use a screed to spread the glue and remove the air bubbles. To do this, drag the tool over the wallpaper from top to bottom and from center to ends.

Step 5:

Clean the excess glue and water using a sponge. Before the adhesive dries, trim the excess wallpaper at the ceiling and floor by using a utility knife. For more precision, use the edge of the screed to guide the blade.

Step 6:

Before anchoring the next length, place it on the wall and adjust its grounds to those of the first. Mark the top and bottom of the strip in advance of the cut. Again, be sure to add approximately 5 cm (2) additional. Ask this band, as well as the following, in the same manner as the first. Make sure you glue the joints.