Doors and gates, which often represent the anger of the home, especially if they are particularly numerous and elaborate. In this guide, we will teach you to clean up your doors in the best way, without damaging them, and above all without particular effort. Because of their function and partition of passage are more prone to dirt, dust that lurks, dirty or greasy hands that touch etc.. Obviously the fear of ruining us whenever we go whale perform routine cleaning, still reading you will discover all the secrets to remove dirt and stains comply with all surfaces.

door-gates

The point at which the doors more often tend to get dirty is around the handle, so it must be cleaned with care and greater frequency. Depending on the material, you can use a different methodology, but basically you proceed to the first dusting of the entire surface with a cloth soft, dry cloth. If they are carved or fluted panels with frames, use a soft brush with natural bristles to reach the most inaccessible corners. Prepare a solution of dish washing liquid and warm water. Rinse with clean water and dry thoroughly with a dry cloth. Proceed from the bottom up, and for the past rinsing the cloth in the opposite direction, in this way you will be sure you have cleaned the entire surface and do not leave annoying streaks.

If your doors are white, clean with a solution of baking soda and water (obtained by dissolving one tablespoon per liter of water), rinse and dry immediately. If you have plastic doors, detergents with water and mild detergent, rinse well and dry. If you intend to elucidate simply is a glass cleaner. If your doors are lacquered wood, use a solution of ammonia and water in a ratio of two tablespoons per liter.

Or to create one protective and polishing the beginning I simply applied the beeswax. For doors in precious wood or natural, proceed to clean using a soft sponge soaked with plenty of wax, let it soak for a couple of days later and polish with a soft cloth over the surface evenly, otherwise the result will be an uneven polishing. To prevent dirt cumuli to remove dust, simply dusting with a feather duster every two days.

In the event that instead you run into special signs, such as burns, bruises, signs of water and fat, try to act in these ways. The spots of alcohol can damage the surface, leaving white marks. Dab immediately drops and rub vigorously interesting area with a simple polish, if it is not enough, try rubbing the grains with a metal polish and a soft cloth. The buns are usually remediable read on the hardwood, simply wipe with a polishing metals and put a sign on the wet paper towel, then cover with plastic wrap and leave on for one night. As for the burns on surfaces furred you can just remove and replace the affected area. For dents must act quickly filled the cavity with warm water and leave to penetrate, or by covering the area with wet paper towel and then wipe it with a hot iron. Water stains should be blotted quickly and then proceed by spreading the metal polish in the direction of the grain and rubbing. The grease spots if not addressed promptly leave a permanent dark mark on the wood, so you have to remove the grease, and wipe it with pure vinegar to dissolve the grease, and then cleaned with a solution of vinegar and warm water in equal parts.