In the air there is always a certain amount of water, this is measured in% and is called the relative humidity of the air as it is in relation to the temperature. The relative humidity changes according to the weather conditions, for example, when it rains is higher when there while the wind is usually lower. In the houses there are several sources that can raise the relative humidity of the air. In a house areas that transmit the cold inside are called Thermal Bridges, are usually on the perimeter walls and around windows and doors where the thickness is less and therefore insufficient insulation. At those points the condensed water wets the surface of the wall and with the passage of time the molds begin to form. A drawback is quite common to that of the door which, at a certain moment, begins to rub on the floor. The causes may be two. One of the causes may be associated moisture. Therefore, you have windows and doors that are subject to moisture? Do not worry, this guide is definitely for you! In fact, with a few simple steps will explain, as clearly and comprehensively as possible, how to repair windows and doors properly attacked by moisture.

how to repair windows

The wood has swollen due to moisture, and in that case have to remove the door and planing the lower end, so as to eliminate the bulge; or it is a failure of the wing due to a defect in the hinges. If these are slightly worn, in correspondence of the sport, just fill in the pivot pin, mounted on the fixed frame, metal washers of thickness adequate; vice versa if the hinges are damaged, we have to strengthen them by inserting longer screws, or replace them.

Can also happen the inconvenience contrary to the one described, namely, that between the door and the floor there is too wide a slit which passes the air: which is very annoying if it is an external door because, in addition to step d ‘air infiltrates even dust. To remedy this trouble simply file the parts of the hinges fixed to the leaf, so reducing them slightly thick.

Without this, however, may present another problem: the lock does not close more perfectly, because the nozzle which is located on the fixed frame does not match with the position of the bolt more. It only remains to slightly file the bottom, or top, of the nozzle, so as to enlarge sufficiently to allow the lock to enter smoothly.