With costs growing daily in everyday items, people try to save money anyway. Install a synthetic garden not only save money on your water bill but uses recyclable plastic and also saves people a precious time in caring for the garden. Do not use water, no mowing the lawn and no weeds.

There is also the added benefit that the grass is always green, and the garden can increase the floor of your house. If you live in Phoenix and look for the right synthetic turf provider, trust Faithfully Green that also provides synthetic grass installation Phoenix. It’s even cheaper in very arid areas such as deserts, and in shady areas where grass does not grow well.
Installing synthetic grass


1.) Think about what area you want to install your garden with artificial and perfílala spray paint. After you remove the existing grass and / or ground cover with a shovel or a lawn extractor. Ideally, you need from 2 to 3 inches of the substrate at a slight angle for drainage, taking into account your final mix will have to fill naturally with the existing landscape.

2.) If a sprinkler system, turn the valves and plugs put sprinklers. After the substrate using a compact vibration plate rented. Make sure the ground is firm and solid, followed by a scavenger of weeds and grass.

3.) Extends a network that makes a barrier for weeds in the area, making sure it is dry as you go. Interbase covered with stone aggregate, making sure to stay at least 1/4 inch below the surface. Do it twice, compacting with a vibratory compactor.

4.) Spread a thin layer of sand over the entire area to create a depth of the upper base of about 1/8 inch, using your seed dealer. Then checks whether any area of more than 1/8 of an inch where the water is collected and penetrates.

5.) Extends the grass and position it in the desired area, trying not to drag. No cuts to be sure that it is positioned correctly. Cut off any excess with a utility knife with a sharp blade, and then ends with a more accurate straight cut. After extending the next section of the lawn.

6.) The joint where the edges of the two sections join is created. Gasket tape cut the same length as the line. Extends to be adjacent reefs, making sure the pattern lines the bottom stitches going in the same direction and the edges have been cut cleanly. The seams must match and fit well.

7.) Strip both reefs back to install the tape; center it on both edges. Use a rake and apply glue to the strip joint. Put one edge of the grass in the middle of the sealing tape and repeat with the other piece, distributing evenly over the tape. Use your fingers to engage the fibers and allow the glue to dry for 24 hours.

8.) Cut the outstanding garden lawn that has the right look and then put cloves 4-6 inches long across the lawn and into the substrate around the perimeter at approximately one-foot intervals. After passing the rake across the surface in a direction opposite to the one with the grass on the roll, in preparation for the filling.

9.) Fill the seed distributor and/or rubber filler. To weigh and stabilize the lawn calculates the depth to 1 1/2 pounds of sand 1/2 inch tall rubber or 1 pound per square foot per 1/2 inch filling height. Using several steps, distributes the filling, causing a complete pass over the surface and within the fibers after sweeping and repeated using whole filler.